CONTENTSCONTENTS

CONTENTS

1. LEGISLATIVE PROVISIONS.....................................3

2. FUNCTION....................................................3

3. APPLICABILITY...............................................3

4. DEFINITIONS..................................................3

5. REQUIREMENTS...............................................3

6. EXEMPTIONS AND ALTERNATIVE PROCEDURES.................3

7. ALTERNATIVE STANDARDS....................................4

APPENDIX A.........................................................5

NOTES .............................................................32

1. LEGISLATIVE PROVISIONS
   1. Name of Standard
      1. This Standard is the Vehicle Standard (Australian Design Rule 87/00 – Cornering Lamps) 2016.
      2. This Standard may also be cited as Australian Design Rule 87/00 – Cornering Lamps.
2. FUNCTION
   1. The function of this standard is to prescribe photometric requirements for Cornering Lamps, which are used to provide supplementary illumination of that part of the road which is located near the forward corner of the vehicle at the side towards which the vehicle is going to turn.
3. APPLICABILITY
   1. The circumstances under which Cornering Lamps are mandatory, optional or prohibited are set out in either ADR 13/…, or 67/… as applicable.
4. DEFINITIONS
   1. For vehicle categories, definitions and meanings used in this standard, refer to:
      1. Definitions in Appendix A of this standard; and where there is no conflict;
      2. Vehicle Standard (Australian Design Rule Definitions and Vehicle Categories) 2005.
5. REQUIREMENTS
   1. Vehicles subject to the requirements of this standard must comply with the requirements of Appendix A, except as varied by Section 6 Exemptions and Alternative Procedures.
   2. In place of Regulation No 37 where referenced in Appendix A, read ADR 51/00.
   3. In place of Regulation No 48 where referenced in Appendix A, read ADR 13/00.
6. EXEMPTIONS AND ALTERNATIVE PROCEDURES
   1. Compliance with the following parts, sections and annexes of Appendix A is not required for the purposes of this standard:

Section 1 Scope