CONTENTSCONTENTS

CONTENTS

1. LEGISLATIVE PROVISIONS.....................................3

2. FUNCTION....................................................3

3. APPLICABILITY...............................................3

4. DEFINITIONS..................................................3

5. REQUIREMENTS...............................................3

6. EXEMPTIONS AND ALTERNATIVE PROCEDURES.................3

7. ALTERNATIVE STANDARDS....................................4

APPENDIX A.........................................................5

NOTES .............................................................30

1. LEGISLATIVE PROVISIONS
   1. Name of Standard
      1. This Standard is the Vehicle Standard (Australian Design Rule 86/00 – Parking Lamps) 2016.
      2. This Standard may also be cited as Australian Design Rule 86/00 – Parking Lamps.
2. FUNCTION
   1. The function of this standard is to prescribe the photometric requirements for Parking Lamps, which are intended to be used to draw attention to the presence of a stationary vehicle.
3. APPLICABILITY
   1. The circumstances under which Parking Lamps are mandatory, optional or prohibited are set out in ADR 13/…, ADR 19/…, or 67/… as applicable.
4. DEFINITIONS
   1. For vehicle categories, definitions and meanings used in this standard, refer to:
      1. Definitions in Appendix A of this standard; and where there is no conflict
      2. Vehicle Standard (Australian Design Rule – Definitions and Vehicle Categories) 2005.
5. REQUIREMENTS
   1. Vehicles subject to the requirements of this standard must comply with the requirements of Appendix A, except as varied by Section 6 Exemptions and Alternative Procedures.
   2. In place of Regulation No. 37 where referenced in Appendix A, read ADR 51/00.
   3. In place of Regulation No. 48 where referenced in Appendix A, read ADR 13/00.
6. EXEMPTIONS AND ALTERNATIVE PROCEDURES
   1. Compliance with the following parts, sections and annexes of Appendix A is not required for the purposes of this standard:

Section 1 Scope

Section 3 Application for approval

Section 4 Markings