sch.3-sec-oc.2Industrial development

sch.3-sec-oc.2 Industrial development

Industrial development

(1) Must be external alterations.

(2) Must only be carried out in Zone E4.

(3) Roofing must be of pre-coloured materials.

(4) Must be face brick, pre-coloured metal cladding, textured finish or painted masonry and ‘tilt-slab’ concrete, or a combination of these materials.

(5) Must not be constructed within 1m of any easements or sewer mains.

(6) The floor space ratio (including any mezzanine areas) must not be more than 0.5:1.

(7) Ground level (existing) must not be cut or filled so as to alter by more than 2.0m.

(8) The front setback must be at least 6m.

(9) Awnings or eaves must be at least 1m from the side and rear setbacks required by the Building Code of Australia for the intended use of the building.

(10) A minimum 2m wide landscape area must be provided along all street frontages.

(11) Parking spaces must be provided on the site at the rate of 1 space per 70m2 of gross floor area.

(12) Parking spaces and turning areas must comply with AS 2890.1:2004, Off-street car parking.

(13) Internal driveways must provide access to the building or separate occupancy to accommodate a rigid truck that is at least 11m long, in compliance with AS 2890.1:2004, Off-street car parking, sufficient to allow such trucks to enter and leave the site in a forward direction.

(14) All internal roadways must be constructed to an all-weather bitumen or concrete surface in accordance with Council’s Aus-Spec #1 Design and Construction Specifications.

(15) Storage areas and waste bins must be screened from the street frontage and provided behind the building line.