1CASA 456/05 - Instructions – specifying minimum runway width for an aeroplane

Image unavailable in extracted text
Instrument number CASA 456/05

I, patrick stuart murray, Group General Manager, Air Transport Operations, a delegate of CASA, make this instrument under subregulation 235A (1) of the Civil Aviation Regulations 1988 (CAR 1988)

[Signed Patrick Murray]

Patrick Murray

Group General Manager

Air Transport Operations

08 November 2005

Instructions — specifying minimum runway width for an aeroplane

1 Application

This instrument applies only to operations in Australia of the prototype A380‑841 type aeroplane (the aircraft) by Airbus Industrie (the operator) for airport evaluation purposes.

2 Instructions

(1)The minimum runway width applicable to the aircraft is 60 metres.

(2)However, when operating in accordance with the conditions mentioned in Schedule 1, the minimum runway width applicable to the aircraft may be reduced to 45 metres.

3 Duration

This instrument:

(a) commences on 11 November 2005; and

(b) stops having effect at the end of 16 November 2005.

Schedule 1 Conditions for subsection 2 (2)

1 Landing and take-off operations (operations) may be conducted only at the following airports:

(a) Brisbane International Airport;

(b) Sydney International Airport;

(c) Melbourne International Airport.

2 Operations may only take place at the airports on a runway that is at least 45 metres wide.

3 Operations must comply with CASA special flight authorisation number CBR‑26/2005 of 4 November 2005.

4 During operations, the pilot in command of the aircraft must observe all operating limitations that are specified in the Temporary Permit to Fly issued by the Direction Generale de 1’Aviation Civile, dated 13 September 2005 and applicable to aircraft registered F‑WWOW.