CTHIn ForceLegislation
AD/F100/84 - Fuel Crossfeed Valve and Fire Shut-Off Actuators
Fokker F28 Series AeroplanesFokker F28 Series Aeroplanes
Start here
Get a plain-English read of Fokker F28 Series Aeroplanes
Turn the raw legal text into a practical explanation grounded in AD/F100/84 - Fuel Crossfeed Valve and Fire Shut-Off Actuators.
Fokker F28 Series Aeroplanes
| AD/F100/84 | Fuel Crossfeed Valve andFire Shut-Off Actuators | 7/2007 |
|---|
| Applicability: | F28 Mark 0070 and Mark 0100 aircraft, serial numbers 11244 through 11585 inclusive, if equipped with fuel crossfeed valve- and fuel fire shut-off valve actuators, Part Number (P/N) 9409122. |
|---|---|
| Requirement: | 1. Perform an operational check of, and application of grease on, the LH and RH fuel crossfeed valve actuators and fuel fire shut off valve actuators as defined in Part 1 of SBF-100-28-049 or later NAA approved revision.2. a. Perform a visual inspection of the applied grease layer on the LH and RH fuel crossfeed valve actuators and fuel fire shut off valve actuators as defined in Part 2 of SBF-100-28-049 or later NAA approved revision; andb. Perform an operational check and visual inspection of the LH and RH fuel crossfeed valve actuators and fuel fire shut off valve actuators as defined in Part 3 of SBF-100-28-049 or later NAA approved revision.3. When, during any of the inspections as required by Requirement 2a of this AD, the layer of grease on any valve actuator is found to be insufficient (less than approx. 2 - 3 mm), repeat the application of grease as defined in Part 1 ofSBF-100-28-049 or later NAA approved revision.4. When a fuel fire shut-off valve actuator fails the operational check as required by Requirements 1 or 2b of this AD, replace the valve actuator with a serviceable part in accordance with the Aircraft Maintenance Manual.5. When a fuel crossfeed valve actuator fails the operational check as required by Requirements 1 or 2b of this AD, replace the valve actuator with a serviceable part in accordance with the Aircraft Maintenance Manual or operate the aircraft in accordance with (the conditions and remarks in) MMEL item 28-23-1.Note: EASA AD 2007-0122 dated 3 May 2007 refers. |
| Compliance: | 1. Within 30 days after the effective date of this AD, unless previously accomplished. |
| 2. After compliance with paragraph 1 of this directive:a. At intervals not to exceed 7 days.b. At intervals not to exceed 28 days.3. Before further flight after the effective date of this AD.4. Before further flight after the effective date of this AD.5. Before further flight after the effective date of this AD. | |
|---|---|