CTHIn ForceLegislation
AD/CON/84 Amdt 3 - Starter Adapter Assembly
Teledyne Continental Motors Piston EnginTeledyne Continental Motors Piston Engines
Start here
Get a plain-English read of Teledyne Continental Motors Piston Engin
Turn the raw legal text into a practical explanation grounded in AD/CON/84 Amdt 3 - Starter Adapter Assembly.
Teledyne Continental Motors Piston Engines
| AD/CON/84 Amdt 3 | Starter Adapter Assembly | 5/2007 |
|---|
| Applicability: | Teledyne Continental Motors (TCM) GTSIO-520 series reciprocating engines.Note 1: These engines are installed on, but not limited to, Twin Commander (formerly Aero Commander) model 685, Cessna model 404, 411 series, and 421 series, British Aerospace, Aircraft Group, Scottish Division model B.206 series 2 and Aeronautica Macchi model AM-3 airplanes. |
|---|---|
| Requirement: | 1. For any engine that experiences rough running conditions regardless of time-in-service (TIS), perform the inspection procedures specified in Part 1 and Part 3 of Teledyne Continental Motors (TCM) Mandatory Service Bulletin (MSB) No. MSB94-4G dated 31 October 2005 or later FAA approved revisions, and replace components as necessary.An engine is considered rough-running if there is a sudden increase in the perceived vibration levels that cannot be cleared by adjustment of the engine controls; particularly the fuel mixture setting. Information on rough running engines can be found in the aircraft manufacturer's Airplane Flight Manual, Pilot's Operating Handbook, or Aircraft Owners Manual.Special flight permits are prohibited for rough-running engines described in this AD.2. Perform the inspection procedures specified in Part 2 of MSB94-4G or later FAA approved revisions, and replace components as necessary.3. Perform the inspection procedures specified in Part 3 of MSB94-4G or later FAA approved revisions, and replace components as necessary.4. Install TCM service kit, P/N EQ6642 (new) or EQ6642R (rebuilt), using the service kit installation procedures specified in Part 5 of MSB94-4G dated31 October 2005 or later FAA approved revisions.Note 2: Installation of the service kit does not constitute terminating action for the inspection and component replacements detailed in other requirements of this AD. |
| 5. If, during an inspection in accordance with Requirement 1, 2 or 3 of this AD, you find needle bearing P/N 537721, installed in the crankcase, replace it with a serviceable bushing P/N 654472 or equivalent approved bearing. Use the bushing installation procedure specified in Part 4 of TCM MSB94-4G or later FAA approved revisions.Note 3: FAA Airworthiness Directive AD 2007-05-15 Amendment 39-14976 dated12 March 2007 refers. |
|---|