CTHIn ForceLegislation
AD/B727/100 Amdt 4 - Elevator Rear Spar
Boeing 727 Series AeroplanesBoeing 727 Series Aeroplanes
Start here
Get a plain-English read of Boeing 727 Series Aeroplanes
Turn the raw legal text into a practical explanation grounded in AD/B727/100 Amdt 4 - Elevator Rear Spar.
Boeing 727 Series Aeroplanes
| AD/B727/100 Amdt 4 | Elevator Rear Spar | 11/2008 DM |
|---|
| Applicability: | Boeing model 727 series aircraft, line numbers 1 through 1832. |
|---|---|
| Requirement: | Action in accordance with the technical requirements of FAA AD 2008-17-14 Amdt 39-15652.Note: Boeing Service Bulletin 727-55-0089Revision 1, or later FAA approved revision, refers. |
| Compliance: | As specified in the requirement document. |
| This Amendment becomes effective on 2 October 2008. | |
| Background: | Several cases of fatigue cracking were reported. The cracking was believed to be initiated by interference between the spar flange bend radii and the sharp edges on the shear plates mounted between the spar and the elevator tab hinges.Amendment 1 introduced SB 727-55-0087, which similarly covers the early design elevator rear spar as a result of recent Australian and overseas reports of cracking.Amendment 2 clarified the compliance for operators of certain aircraft.Amendment 3 was issued in response to a new FAA AD which adds new inspections to detect cracks and loose brackets of the elevator rear spar and a new terminating modification for the inspections. Reports were received of cracking in the spar radii at the tab hinge location of the elevator rear spar. |
| Amendment 4 is issued due to change the requirement document from FAA AD96-06-05 to FAA AD 2008-17-14. This directive reduces the repetitive intervals of the inspections, mandates the previously optional terminating action for the repetitive inspections and no longer allows stop-drilling. The FAA received further reports of cracks, elongated fastener holes, and loose fittings of the elevator rear spar. This directive is issued to prevent cracking of the elevator rear spar at the tab hinge locations, which could cause excessive freeplay of the elevator control tab and possible tab flutter, and consequent loss of control. |
|---|
Image unavailable in extracted text
David Villiers
Delegate of the Civil Aviation Safety Authority
2 September 2008