CTHIn ForceLegislation
AD/AT-6/2 Amdt 1 - Horizontal Stabliser Rear Spar Connector Fittings
Rockwell (N American) & Autair (NoorduynRockwell (N American) & Autair (Noorduyn) AT-6, BC-1A, SNJ, T-6G, Harvard, & AT-16 Series Aeroplanes
Start here
Get a plain-English read of Rockwell (N American) & Autair (Noorduyn
Turn the raw legal text into a practical explanation grounded in AD/AT-6/2 Amdt 1 - Horizontal Stabliser Rear Spar Connector Fittings.
Rockwell (N American) & Autair (Noorduyn) AT-6, BC-1A, SNJ, T-6G, Harvard, & AT-16 Series Aeroplanes
| AD/AT-6/2 Amdt 1 | Horizontal Stabliser RearSpar Connector Fittings | 7/2009 |
|---|
| Applicability: | All Model Harvard 2 and Harvard 4 aircraft and Model AT-6D (SNJ-5), AT-6F(SNJ-6), SNJ-7 and T-6G aircraft; equipped with single piece design horizontal stabiliser rear spar connector fittings, part number 7721021 (4 fittings per spar).This Directive is not applicable to aircraft equipped with two piece design connector fittings part numbers 77210213 and 77210214 (8 fittings per spar). |
|---|---|
| Requirement: | Remove the fuselage to vertical stabiliser fairing assembly and the rear fairing assemblies at the horizontal stabiliser.Remove the ¼-inch bolts which attach the upper and lower spar connection fittings part number 7721021, of the rear spar assembly.Remove the four connection fittings from the spar, remove the paint from the connection fittings, and check for cracks using dye penetrant inspection method. Replace any cracked fittings with serviceable fittings and repaint the fittings found to be crack free.Inspect the fit between the connection fittings and the spar with a feeler gauge before installation of the bolts. If gaps greater than 0.010-inches exist, shims are necessary.Fabricate aluminium shims 3 ⅛ -inch x 15/16 -inch and of necessary thickness, and place on either side of spar flanges, maintaining a parallel overall dimension to fit inside the connection fitting with a maximum clearance of 0.010-inches.Drill holes through the shims to match those of the fitting. Remove all drilling chips, and reinstall bolts and other removed parts in accordance with the aircraft maintenance manual.Note: Transport Canada AD CF-82-23 and FAA AD 81-14-10 refer. |
| Compliance: | Unless previously accomplished, before 31 July 2009. |
| This Amendment becomes effective on 2 July 2009. |
| Background: | The Canadian Airworthiness Authority required accomplishment of the requirements this Directive to detect cracking of the horizontal stabiliser rear spar connector fittings, and to check the fit of the connector fittings and the spar.Amendment 1 adds aircraft specified in FAA AD 81-14-10, which has the same requirements as this Directive, to the applicability section. This amendment is issued to ensure compliance of future imported aircraft. |
|---|