Vehicle Standard (Australian Design Rule 79/01 — Emission Control for Light Vehicles) 2005
© 2026 Zoe. All rights reserved.
Zoe is a legal information platform. Always consult the Federal Register of Legislation for authoritative text.
Vehicle Standard (Australian Design Rule 79/01 — Emission Control for Light Vehicles) 2005
Start here
Turn the raw legal text into a practical explanation grounded in Vehicle Standard (Australian Design Rule 79/01 — Emission Control for Light Vehicles) 2005.
5.1 The following provisions of Appendix A do not apply to this vehicle standard:
Section 3 Application for Approval
Section 4 Approval
Section 6 Modifications of the vehicle type
Section 8 Conformity of production
Section 9 Penalties for non-conformity of production
Section 10 Production definitely discontinued
Section 11 Transitional provisions
Section 12 Names and addresses of technical services responsible for conducting approval tests, and of administrative departments
Appendix 1 Procedure for verifying the conformity of production requirements if the production standard deviation given by the manufacturer is satisfactory
Appendix 2 Procedure for verifying the conformity of production requirements if the production standard deviation given by the manufacturer is either not satisfactory or not available
Appendix 3 In-service conformity check
Appendix 4 Statistical procedure for in-service conformity check
Annex 1 Engine and Vehicle Characteristics
Annex 2 Communication
Annex 3 Arrangements of the Approval Mark
5.2 In paragraph 1.1.7 of Appendix A, insert the words "M1, M2 or" after "category" and replace the words "pursuant to Regulation 49 as amended by the last series of amendments" with the words "to ADR80/01 or ADR80/02".
5.3 In paragraph 1.2 of Appendix A, the words “Regulation No. 49” are amended to read “ADR80/01 or ADR80/02”.
5.4 In section 5 of Appendix A, delete the entire Note immediately following the heading “5. SPECIFICATIONS AND TESTS”.
5.5 Bi-fuel vehicles when operated in the LPG or NG mode, and mono-fuel vehicles fuelled with LPG or NG, are not required to comply with the OBD system requirements and tests referred to in paragraph 5.2.2, Table 1, paragraph 5.3.8 and Annex 11 of Appendix A.
5.6 Notwithstanding the applicability of the Type VI test as specified in paragraph 5.2.1 and Table 1 of Appendix A, the Type VI test may be applied in accordance with the requirements of paragraph 5.3.5.1 of Appendix A.
5.7 For the conduct of the Type VI test, the reference fuel specified in paragraph 1.1 of Annex 10 of Appendix A may be used in lieu of the test fuel specified in paragraph 3.4.1 of Annex 8 of Appendix A.
5.8 Notwithstanding the applicability of the Type II test as specified in paragraph 5.2.1 and Table 1 of Appendix A, the Type II test may be applied in accordance with the requirements of paragraph 5.3.2.1 of Appendix A.
5.9 Notwithstanding that Section 8 and Appendices 1, 2, 3 and 4 of Appendix A have been declared not applicable in 5.1 above, the requirements and procedures set out in these appendices are acceptable for the purposes of demonstrating compliance with the technical requirements of this vehicle standard.