- EXEMPTIONS AND ALTERNATIVE PROCEDURES
6.1. Compliance with the following parts, sections and annexes of Appendix A is not required for the purposes of this standard:
Section 1 Scope, paragraph 1.3, 1.5 (see Note 1. below)
Section 3 Application for approval
Section 4 Markings
Section 5 Approval
Section 6 Specifications, paragraph 6.1.1
Section 7 Tests, paragraph 7.1 (however, 7.1.1 to 7.1.4 must be met)
Section 8 Requirements concerning the installation in the vehicle, paragraphs 8.1.5, 8.1.8 and 8.3.5
Section 9 Conformity of production
Section 10 Penalties for non-conformity of production
Section 11 Modifications and extension of approval of the vehicle type or safety-belt or restraint system type
Section 12 Production definitely discontinued
Section 13 Instructions
Section 14 Names and addresses of technical services responsible for conducting approval tests, and of administrative departments
Section 15 Transitional provisions
Annexes
Annex 1A Communication concerning the approval or extension or refusal or withdrawal of approval or production definitely discontinued of a vehicle type with regard to safety-belt pursuant to Regulation No. 16
Annex 1B Communication concerning the approval or extension or refusal or withdrawal of approval or production definitely discontinued of a type of safety-belt or restraint system for adult occupants of power-driven vehicles pursuant to Regulation No. 16
Annex 2 Arrangements of approval marks
Annex 9 Instructions, paragraphs 3. and 4
Annex 14 Control of conformity of production
Annex 17 Requirements for the installation of safety-belts and restraint systems for adult occupants of power driven vehicles on forward facing seats and for the installation of ISOFIX child restraint systems.
Note 1.: The requirements for ISOFIX child restraint systems are set out in ADR 34/....
6.2. Appendix A paragraphs 8.1.7.1 and 8.1.7.3 are not applicable to this standard.
6.3. Where a seat is a suspension seat and not all the anchorages are mounted on the moving part of the seat, an emergency locking retractor with higher response threshold of type 4N (Appendix A, paragraph 2.14.5) may be fitted instead of an emergency locking retractor of type 4 (Appendix A, paragraph 2.14.4).
6.4. An automatically locking retractor of type 3 (Appendix A, paragraph 2.14.3) may be fitted instead of an emergency locking retractor of type 4 (Appendix A, paragraph 2.14.4) to any front or second row outboard seating position other than the driver’s for LEP, MA, MB MC and NA category vehicles and to any outboard seating position other than the driver’s for MD1 and MD2 category vehicles and forward control MB category vehicles.
6.5. Where the manufacturer has elected not to meet Appendix A Section 5 Approval, the manufacturer's name, initials or trade name or mark must be affixed in a suitable space to every seatbelt. The particulars must be clearly legible and be indelible, and may be permanently affixed either by means of a label or by direct marking. The label or marking must be resistant to wear.
6.6. Notwithstanding the requirements of Appendix A, paragraph 6.4.1.4, the movement of the chest reference point for a seatbelt intended to be used in an outboard front seating position may exceed that specified in Appendix A, paragraph 6.4.1.3.2. if a vehicle meets the requirements of ADR 69/….