Vehicle Standard (Australian Design Rule 4/04 – Seatbelts) 2006
B 4 mB 4 m
Start here
Get a plain-English read of B 4 m
Turn the raw legal text into a practical explanation grounded in Vehicle Standard (Australian Design Rule 4/04 – Seatbelts) 2006.
B 4 m
Image unavailable in extracted text
The belt bearing the above approval mark is a lap belt ("B"), fitted with a retractor, type 4, with multiple sensitivity (m) and approved in the Netherlands (E4) under the number 042489, the Regulation already incorporating the 04 series of amendments at the time of approval.
NOTE:The approval number and additional symbol(s) must be placed close to the circle and either above or below the "E" or to left or right of that letter. The digits of the approval number must be on the same side of the "E" and orientated in the same direction. The additional symbol(s) must be diametrically opposite the approval number. The use of roman numerals as approval numbers should be avoided so as to prevent any confusion with other symbols.
Image unavailable in extracted text
The belt bearing the above approval mark is a special type belt ("S"), fitted with an energy absorber ("e") and approved in the Netherlands (E4) under the number 0422439, the Regulation already incorporating the 04 series of amendments at the time of approval.
Image unavailable in extracted text
The belt bearing the above approval mark is part of a restraint system ("Z"), it is a special type belt ("S") fitted with an energy absorber ("e"). It has been approved in the Netherlands (E4) under the number 0424391, the Regulation already incorporating the 04 series of amendments at the time of approval.
Image unavailable in extracted textImage unavailable in extracted text
Image unavailable in extracted text
a = 8 mm min.
Image unavailable in extracted text
The belt bearing this type‑approval mark is a three‑point belt ("A") with a multiple‑sensitivity ("m") type 4N ("r4N") retractor, in respect of which type‑approval was granted in the Netherlands ("E4") under number 042439, the Regulation already incorporating the 04 series of amendments at the time of approval. This belt shall not be fitted to vehicles of category M1.
Image unavailable in extracted text
The safety-belt bearing this type-approval mark is a three-point belt ("A") fitted with an energy absorber ("e"), approved as meeting the specific requirements of paragraph 6.4.1.3.3. of this Regulation, and with a multiple-sensitivity ("m") type 4 ("r4") retractor, in respect of which type approval was granted in the Netherlands ("E4") under the approval number 042439. The first two digits indicate that the Regulation already incorporated the 04 series of amendments at the time of the approval. This safety-belt has to be fitted to a vehicle equipped with an airbag in the given seating position.