Vehicle Standard (Australian Design Rule 4/04 – Seatbelts) 2006
Annex 2Annex 2
Start here
Get a plain-English read of Annex 2
Turn the raw legal text into a practical explanation grounded in Vehicle Standard (Australian Design Rule 4/04 – Seatbelts) 2006.
Annex 2
ARRANGEMENTS OF THE APPROVAL MARKS
- Arrangements of the vehicle approval marks concerning the installation of safety-belts
Model A
(See paragraph 5.2.4. of this Regulation)
Image unavailable in extracted text
a = 8 mm min.
The above approval mark affixed to a vehicle shows that the vehicle type concerned has, with regard to safety-belts, been approved in the Netherlands (E4) pursuant to Regulation No. 16. The approval number indicates that the approval was granted according to the requirements of Regulation No. 16 as amended by the 04 series of amendments.
Model B
(See paragraph 5.2.5. of this Regulation)
Image unavailable in extracted text
a = 8 mm min.
The above approval mark affixed to a vehicle shows that the vehicle type concerned has been approved in the Netherlands (E4) pursuant to Regulations Nos. 16 and 52. 1[/ The approval numbers indicate that, at the dates when the respective approvals were given, Regulation No. 16 included the 04 series of amendments and Regulation No. 52 the 01 series of amendments. ]
- Arrangements of the safety-belt approval marks (See paragraph 5.3.5. of this Regulation)
Image unavailable in extracted text
Image unavailable in extracted text
a = 8 mm min.
The belt bearing the above approval mark is a three‑point belt ("A"), fitted with an energy absorber ("e") and approved in the Netherlands (E4) under the number 042439, the Regulation already incorporating the 04 series of amendments at the time of approval.