Commonwealth legislation

Tariff Concession Order 0502546

In ForceCTH

Jurisdiction

Commonwealth

Collection

legislative instrument

Plain English Summary

2/10 complexity

This Order declares a specific type of steel-strip-rolling-mill pinion (defined by outside diameter, length and heat treatment) to be covered by an item in Part III of Schedule 4 to the Customs Tariff Act 1995, effective 23 February 2005. That makes those imports eligible for the tariff treatment set in Schedule 4. It affects importers of these pinions (who pay the concessional tariff if the goods meet the description). The declaration was made by a delegate of the CEO under s.269P and lasts until revoked under ss.269SC/269SD.

JSON API

Deep dive

Want the full deep dive?

Zoe can write the in-depth analysis on top of the summary above: how it works, who it affects and what each part actually does.

Current sections

Direct links to the current provisions in Tariff Concession Order 0502546.

Tariff Concession Order 0502546

_______________________________________________________________________________________________________________________________

| |

| TARIFF CONCESSION ORDER |

| |

|Under Section 269P of the Customs Act 1901, I Rod Wise a delegate of the Chief Executive Officer |

|declare that the goods specified in Column 1 of THE TABLE are goods to which the item in Part III of Schedule 4 to the Customs |

|Tariff Act 1995 specified in Column 2 of THE TABLE applies. This Order shall have effect from FEBRUARY 23, 2005 and |

|continue in force until revoked under sections 269SC or 269SD of the Act, or the date, if any, specified in Column 2. |

|_______________________________________________________________________________________________________________________________|

THE TABLE

_______________________________________________________________________________________________________________________________

COLUMN 1 COLUMN 2

Description of Goods including the Prescribed Item No.

Customs Tariff Classification Date

_______________________________________________________________________________________________________________________________

8483.40.90 PINIONS, STEEL STRIP ROLLING MILL, having ALL of the following: 50

(a) outside diameter greater than 550 mm;

(b) length greater than 1 480 mm;

Op. 23.02.05 - TC 0502546

_______________________________________________________________________________________________________________________________

|This is page 1 of 1 page(s) of the above Table. |

| ..Rod Wise.................................... |

|Dated MAY 6, 2005 Delegate of the Chief Executive Officer |

|_______________________________________________________________________________________________________________________________|

Source text

Sourced from the Federal Register of Legislation (legislation.gov.au), CC BY 4.0.

1 Tariff Concession Order 0502546

_______________________________________________________________________________________________________________________________

| |

| TARIFF CONCESSION ORDER |

| |

|Under Section 269P of the Customs Act 1901, I Rod Wise a delegate of the Chief Executive Officer |

|declare that the goods specified in Column 1 of THE TABLE are goods to which the item in Part III of Schedule 4 to the Customs |

|Tariff Act 1995 specified in Column 2 of THE TABLE applies. This Order shall have effect from FEBRUARY 23, 2005 and |

|continue in force until revoked under sections 269SC or 269SD of the Act, or the date, if any, specified in Column 2. |

|_______________________________________________________________________________________________________________________________|

THE TABLE

_______________________________________________________________________________________________________________________________

COLUMN 1 COLUMN 2

Description of Goods including the Prescribed Item No.

Customs Tariff Classification Date

_______________________________________________________________________________________________________________________________

8483.40.90 PINIONS, STEEL STRIP ROLLING MILL, having ALL of the following: 50

(a) outside diameter greater than 550 mm;

(b) length greater than 1 480 mm;

Op. 23.02.05 - TC 0502546

_______________________________________________________________________________________________________________________________

|This is page 1 of 1 page(s) of the above Table. |

| ..Rod Wise.................................... |

|Dated MAY 6, 2005 Delegate of the Chief Executive Officer |

|_______________________________________________________________________________________________________________________________|