9DElectronic labelling

9D Electronic labelling

(1) A supplier may apply a compliance label to a device using the built‑in display of the device. (2) The supplier must ensure that the documentation that accompanies the device when it is supplied to the user sets out a method for displaying the compliance label. (3) The compliance label must be applied to the device in a way that would make it difficult to prevent the display of the label when the method set out in the documentation is used. (4) Subsection 9(3) and sections 9A and 9C do not apply to a label applied under this section.

Part 2A—Additional labelling requirement for wireless audio transmitters

9E Additional labelling requirement for suppliers of wireless audio transmitters

(1) A supplier who supplies a wireless audio transmitter must also ensure that a label that complies with subsection (2) is applied to the device at the time the device is supplied.
(2) The label must include the following statement in bold type size no less than 5mm high: “This device operates under an ACMA class licence and must comply with all the conditions of that licence including operating frequencies. Before 31 December 2014, this device will comply if it is operated in the 520-820 MHz frequency band. WARNING: After 31 December 2014, in order to comply, this device must not be operated in the 694-820 MHz band. ”
(3) For the purposes of this section, the label is taken to be applied to the device if it is affixed in a prominent position to a container, covering, package, case, box or other thing in or with which the device is supplied.

Note 1: Examples of wireless audio transmitters to which the requirements of section 9E apply include, but are not limited to, wireless microphones, in-ear monitoring devices, wireless musical instrument pickups and other short range devices that are capable of operating in the 694 – 820 MHz frequency range.

Note 2: A label applied under this section is not required to contain an RCM or a compliance mark.