4220GOVERNMENT GAZETTE, WA 13 November 2020

4220 GOVERNMENT GAZETTE, WA 13 November 2020 PLANNING PL401 Shire of Murray Local Planning Scheme No. 4—Amendment No. 311 Ref: TPS/2637 Development Act 2005 that the Minister for Planning approved the Shire of Murray Local Planning Scheme amendment on 4 November 2020 for the purpose of— Modifying the Scheme Map to rezone Lot 221 Lakes Road and parts of Lot 400 Paterson Road, Nambeelup from ‘Rural’ to ‘Industrial Development—Nambeelup’ zone. D. BOLT, Shire President. D. UNSWORTH, Chief Executive Officer. PL404 City of Fremantle Local Planning Scheme No. 4—Amendment No. 77 Ref: TPS/2516 Development Act 2005 that the Minister for Planning approved the City of Fremantle Local Planning Scheme amendment on 4 November 2020 for the purpose of— (a) Rezoning Lot 8 (Nos. 9-15) Quarry Street, Fremantle from Residential with a density coding of R25 to Mixed Use with a density coding of R80, and to amend the density coding of Lots 1 and 2 (No. 5-7) Quarry Street from RAC3 to R80; (b) Modifying Schedule 7—Local Planning Areas (Development Requirements) Local Planning Area 2—Fremantle 2.3.1, Sub Area 1 as follows— 2.3 SPECIFIC DEVELOPMENT CONTROLS FOR SUB AREAS 2.3.1 Sub Area 1

13 November 2020 GOVERNMENT GAZETTE, WA 4221 2.3.1.1 Land Use (a) Notwithstanding the provisions of Table 1—Zoning— (i) Residential uses will not be permitted in new buildings at ground level adjacent to Queen Victoria Street at the following locations— □ between Parry Street and James Street both sides □ for 60 metres north from James Street both sides □ for 30 metres south from Burt Street east side □ for 90 metres south from Beach St west side; and (ii) Except in Area 1a and 1b, non-residential uses will only be permitted above ground level where they meet local needs for commercial services. 2.3.1.2 (b) Clause 2.2 ‘Matters to be considered in applying general and specific height controls’ does not apply to Sub Area 1. (c) Permitted building heights shall be in accordance with the requirements set out in the table below— Building Height and Setbacks Area Permitted Building Height (Metres) Min. Facade Height 1a 12.5 Council may permit a maximum building height of 20 metres for Area 1a where the proposed development satisfies all of the following— (i) Exceptional design quality and distinctive architecture befitting its location (ii) Demonstrate a high standard of environmentally sustainable design, incorporating into the building fabric measures to minimise energy consumption, water usage, emissions and waste (iii) Provide a high quality and publicly accessible pedestrian environment within the site as an extension of the street space at the ground level frontages to Queen Victoria Street and Beach Nil 1b 20 Nil 2 24.5 10 3 18 10 3a 18 10 4 18 10 4a 18 10 4b 15 10 5 11 10 6 11 10 6a As defined by the R-Codes As defined by the R-Codes 7 18 10 7a 18 10 8 18 In granting consent to the maximum 18 metre height prescribed for Area 8 Council shall be satisfied in regard to all of the following— (a) That the proposal is consistent with predominant height patterns of adjoining properties and the locality generally, (b) The proposal would not be detrimental to the amenity of the area, (c) The proposal would be consistent, if applicable, with conservation objectives for the site and locality generally, and (d) Any other relevant matter outlined in Council’s local planning policies. Council may impose a lesser height in the event that the proposal does not satisfy any one or all of the above requirements. (d) In the front elevation of all new development, except fronting Quarry Street, the ground floor level must be no greater than 600mm above the level of the adjacent footpath and the first floor level must be at least 4.5 metres above the level of the footpath adjacent to the site.