1Customs By-law No. 1301124

CUSTOMS ACT 1901

CUSTOMS TARIFF ACT 1995

SCHEDULE 4

BY-LAW No. 1301124

I, Geoff Johannes, delegate of the Chief Executive Officer, under section 271 of the Customs Act 1901 make the by-law set out in the Schedule below.

THE SCHEDULE

Item 49

Schedule 4

1. This by-law may be cited as Customs By-law No. 1301124.

2. This by-law shall take effect on and from 1 March 2013.

3. For the purposes of item 49 of Schedule 4 to the Customs Tariff Act 1995, aluminium sheet that is classified in subheadings 7606.12.00 or 7606.92.00 of Schedule 3 and used in the manufacture of aluminium cans, as follows, is prescribed:

(a) aluminium sheet, for use as bodystock, having all of the following features:

(i) in coils;

(ii) gauge exceeding 0.26 mm but not exceeding 0.28 mm;

(iii) alloy composition of 3004 or 3104 as per International Alloy Designation System;

(iv) temper of H19 as per Australian Standard AS 2848.1;

(v) coated with oil;

(b) aluminium sheet, for use as endstock, having all of the following features:

(i) in coils;

(ii) gauge exceeding 0.23 mm but not exceeding 0.25 mm;

(iii) alloy composition of 5182 as per International Alloy Designation System;

(iv) temper of H19 or H48 as per Australian Standard AS 2848.1;

(v) polymer coated; or

(c) aluminium sheet, for use as tabstock, having all of the following features:

(i) in coils;

(ii) gauge exceeding 0.22 mm but not exceeding 0.32 mm;

(iii) alloy composition of 5082 or 5182 as per International Alloy Designation System;

(iv) temper of H19, H39, H391 or H48 as per Australian Standard AS 2848.1.

4. For the purposes of this by-law, the “Customs Tariff Act 1995” means the Customs Tariff Act 1995, as amended or proposed to be altered.

Dated this twenty fifth day of February 2013.

(signed)

Geoff Johannes

Delegate of the

Chief Executive Officer