79Side and rear setbacks

79 Side and rear setbacks (b) a schedule to that zone in the planning scheme specifies minimum setbacks from side and rear boundaries— a building on the allotment must be set back from a side or rear boundary not less than the relevant setback specified in that schedule. (2) If subregulation (1) does not apply, a building must be set back from a side or rear boundary not less than the distance specified in respect of that boundary in Table 79. Table 79—Side and rear setbacks | *Building height at any point* | *Minimum setback from side or rear boundary at that point* | | 3⋅6 m or less | 1 m | | More than 3·6 m but not more than 6·9 m | 1 m plus an additional distance calculated at the rate of 300 mm for every metre of height over 3·6 m | | More than 6·9 m | 2 m plus an additional distance calculated at the rate of 1 m for every metre of height over 6·9 m | (3) The following may encroach into the setback distance required by subregulation (1) or (2)— (a) landings with an area of not more than 2 m2 and less than 1 m in height; (b) unroofed stairways and ramps; (c) pergolas; (d) shade sails; (e) eaves, fascia and gutters, if the encroachment is not more than 600 mm; (f) carports that comply with regulation 80. (4) The following may encroach into the setback distance required by subregulation (1) or (2) by not more than 500 mm— - 1. porches and verandas; 2. masonry chimneys; 3. sunblinds; 4. permanent and fixed screens referred to in regulation 84(5)(d) or (6); 5. flues, pipes and rainwater heads; 6. domestic fuel tanks and water tanks; 7. heating and cooling equipment and other services. (5) This regulation does not apply to a wall that complies with regulation 80. (6) The report and consent of the relevant council must be obtained to an application for a building permit in relation to a design that does not comply with this regulation.