CTHIn ForceLegislation
AD/TAY/5 Amdt 3 - HP Compressor OGV Segment to Outer Seal Spacer Retaining Bolt Release
Rolls Royce Turbine Engines - Tay SeriesRolls Royce Turbine Engines - Tay Series
Start here
Get a plain-English read of Rolls Royce Turbine Engines - Tay Series
Turn the raw legal text into a practical explanation grounded in AD/TAY/5 Amdt 3 - HP Compressor OGV Segment to Outer Seal Spacer Retaining Bolt Release.
Rolls Royce Turbine Engines - Tay Series
| AD/TAY/5 Amdt 3 | HP Compressor OGV Segment to Outer Seal Spacer Retaining Bolt Release | 3/2005 |
|---|
| Applicability: | Rolls-Royce Aircraft Engine Models TAY 650-15, 650-15/10 and TAY 651-54 that do not incorporate Rolls Royce Service Bulletin (SB)Tay-72-1498 Revision 1 dated 01 December 2000; orTay 72-1498 Revision 2 dated 31 December 2004. |
|---|---|
| Requirement: | 1. Carry out inspection in accordance with Rolls Royce SB Tay-72-1483 Revision 2 dated 20 October 2000.2. Modify the engine in accordance with Rolls Royce SB Tay-72-1498 Revision 2.Note 1: German LBA AD D-2004-365 approved under EASA approval No. 2004-12660 dated 31 December 2004 refers.Note 2: AD D-2004-365 supersedes UK CAA Airworthiness Directives 003-10-2000 and 005-12-99. |
| Compliance: | 1. As detailed in the requirement document.2. (a) At the latest by 31 October 2007 for Engine Models Tay 650-15 and Tay 650-15/10.(b) At the latest by 30 September 2012 for Engine Model Tay 651-54.Note 3: Compliance with Requirement 2 constitutes terminating action for Requirement 1 of this AD. |
| This Amendment becomes effective on 17 March 2005. | |
| Background: | Several incidents of HPC OGV segment to outer seal spacer retaining bolt release have been reported on TAY 650-15 series engines. In extreme cases this has led to cracking of the stage 11-12 spacer. The problem is attributed to the OGV retaining bolts cracking in Low Cycle Fatigue (LCF) at the point where the bolts enter the diffuser case. This is as a result of bending loads imparted by a transient thermal mismatch between the inner seal carrier and the diffuser case flange near Maximum Take Off (MTO). |
| The actions specified by this Airworthiness Directive are intended to prevent HPC OGV segment to outer seal spacer retaining bolt release, which can result in an uncontained engine failure and damage to the airplane.The current amendment revises the compliance dates and makes reference to the latest revision of the applicable Service Bulletins.Amendment 2 of this AD became effective on 25 December 2003.Amendment 1 of this AD became effective on 13 June 2002.The original issue of this AD became effective on 15 June 2000. |
|---|
James Coyne Delegate of the Civil Aviation Safety Authority