CTHIn ForceLegislation
AD/PHS/24 Amdt 1 - Propeller System Actuator Yoke Arms
Propellers - Variable Pitch - Hamilton SPropellers - Variable Pitch - Hamilton Standard
Start here
Get a plain-English read of Propellers - Variable Pitch - Hamilton S
Turn the raw legal text into a practical explanation grounded in AD/PHS/24 Amdt 1 - Propeller System Actuator Yoke Arms.
Propellers - Variable Pitch - Hamilton Standard
| AD/PHS/24 Amdt 1 | Propeller System Actuator Yoke Arms | 10/2006 |
|---|
| Applicability: | Hamilton Sundstrand Model 14RF-19 propellers with propeller system actuator yoke arms, part number (P/ N) 810436-2, which might be installed in actuator assemblies P/N 790199-6.Note 1: These propellers are installed on, but not limited to, SAAB 340 aeroplanes. |
|---|---|
| Requirement: | 1. Replace all actuator yoke arms, P/N 810436-2 with improved actuator yoke arms, P/N 810436-3 in accordance with the Accomplishment Instructions of Hamilton Sundstrand Service Bulletin 14RF-19-61-113, Revision 1, dated 2 September 2003 or later FAA approved revisions.2. Mark newly installed actuators in accordance with the Accomplishment instructions of Hamilton Sundstrand Service Bulletin 14RF-19-61-113, Revision 1, or later FAA approved revisions.3. Do not install any actuator yoke arms, P/N 810436-2, into any propeller assembly.Note 2: FAA AD 2006-16-01 Amdt 39-14701 dated 24 July 2006 refers. |
| Compliance: | 1. Within 60 days after the effective date of this AD, unless previously accomplished.2. Within 60 days after the effective date of this AD, unless previously accomplished.3. From the effective date of this AD. |
| This Amendment becomes effective on 28 September 2006. | |
| Background: | This AD results from propeller system actuator yoke arms breaking during flight. The requirements of this AD are intended to prevent actuator yoke arms breaking during flight, which could cause high propeller vibration and contribute to reduced controllability of the aeroplane.This amendment corrects an error in the applicability section of the AD, where the actuator assembly was given the wrong P/N. |
| The original issue of the AD became effective on 3 August 2006. |
|---|
Image unavailable in extracted text
James Coyne
Delegate of the Civil Aviation Safety Authority
14 August 2006