---

meta-content-style-type: text/css meta-content-type: application/xhtml+xml; charset=utf-8 meta-generator: Aspose.Words for .NET 22.10.0

?xml version="1.0" encoding="utf-8" standalone="no"?>

COMMONWEALTH OF AUSTRALIA (Civil Aviation Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY

SCHEDULE OF AIRWORTHINESS DIRECTIVES

 

Image unavailable in extracted text GAF N22 and N24 Series Aeroplanes

 

AD/GAF-N22/58

Amdt 5

Applicability: All models.

Horizontal Stabiliser 8/96

 

Requirement: 1. Remove modification N568 machined braces, P/N 1/N-30-250, and inspect the horizontal stabiliser centre section structure, in accordance with ASTA Nomad Service Bulletin ANMD-55-26, Revision 8, Accomplishment Instructions, Part 1.

 

2.    Reinforce the dorsal fin & the rear fuselage structure, in accordance with ASTA Nomad SB ANMD-55-26, Revision 8, Accomplishment Instructions, Part 2.

 

3.    Rework the horizontal stabiliser structure and install modification N663 and N768, in accordance with ASTA Nomad Service Bulletin ANMD-55-26, Revision 8, Accomplishment Instructions, Part 3 or 4 as applicable.

 

Note: For the purposes of this AD, installation of modifications N663 and N768 does not 'zero time' the tailplane.

 

4.    Retire the complete horizontal stabiliser structure from service, including trim tab assemblies.

 

Compliance: Accomplish Requirements 1, 2 and 3 before further flight, unless previously accomplished, except that changes introduced by Revision 8 of SB ANMD-55-26, including new lockwire requirements, may be accomplished not later than the next issue of a Maintenance Release after 18 July 1996.

 

For tailplanes with the original main spars, or that were resparred at less than 5000 hours tailplane time in service, retire the horizontal stabiliser from service before exceeding 15000 hours spar time in service; or

 

For tailplanes resparred after 5000 hours tailplane time in service, retire the horizontal stabiliser from service before 20,000 hours tailplane time in service.

 

Note: For the purposes of this AD, "resparred" means a complete main spar 'tip to tip' and centre section box replacement.

 

Background: This directive arose from field reports of cracking in the stabiliser centre section.

Investigation of a fatal tailplane failure suggested that undetected cracks may propagate beyond safe limits, despite relatively stringent inspections. Reports have also been received of cracks occurring in the spar cap flanges fitted with modification N569. This modification impedes inspection of the area and is required to be removed.