CTHIn ForceLegislation
AD/DA42/5 - Aileron Bellcrank and Rod Ends
Diamond DA42 Series AeroplanesDiamond DA42 Series Aeroplanes
Start here
Get a plain-English read of Diamond DA42 Series Aeroplanes
Turn the raw legal text into a practical explanation grounded in AD/DA42/5 - Aileron Bellcrank and Rod Ends.
Diamond DA42 Series Aeroplanes
| AD/DA42/5 | Aileron Bellcrank and Rod Ends | 7/2008 |
|---|
| Applicability: | Diamond Aircraft Industries GmbH DA 42 and DA 42 M aircraft, fitted with aileron bellcranks Part Number (P/N) DA4-2717-50-00.Note 1: The following DA 42 and DA 42 M aircraft are known to have been delivered with P/N DA4-2717-50-00 Bellcrank and bent P/N DAI-9027-00-01 rod ends installed: Serial numbers 42.008 through 42.285, 42.287, 42.289 through 42.291, 42.295, 42.297, 42.301, 42.302, 42.306 through 42.308; and 42.AC001 through 42.AC110, inclusive. |
|---|---|
| Requirement: | 1. Replace the P/N DA4-2717-50-00 aileron bellcrank with the improved design P/N DA4-2717-50-00_01 aileron bellcrank and replace any bent rod endsP/N DAI-9027-00-01 with straight parts, in accordance with Diamond Aircraft Industries GmbH Mandatory Service Bulletin (MSB) 42-043or later NAA approved revision.2. Do not install a P/N DA4-2717-50-00 aileron bellcrank or bent rod endsP/N DAI-9027-00-01 on any aircraft as replacement parts.Note 2: EASA AD 2008-0086 dated 13 May 2008 refers. |
| Compliance: | For Requirement 1: Within the next 200 flight hours after the effective date of this AD unless previously accomplished.For Requirement 2: From the effective date of this AD. |
| This Airworthiness Directive becomes effective on 3 July 2008. | |
| Background: | The original designed bellcrank for the aileron control system in the wing needed to be installed with slightly bent rod ends during production of the aircraft to avoid friction and possible chafing. In addition to being a non-preferable production practice, this creates the risk of replacement parts being installed during subsequent in-service maintenance without being bent or not being bent correctly. This condition, if not detected and corrected, could lead to chafing damage of the aileron control system and consequent loss of control of the aircraft. |
| Diamond Aircraft Industries GmbH has now developed a new aileron bellcrank that allows for additional angular movement of the push rod, thereby eliminating the chafing risk without using bent rod ends. This AD requires the replacement of the aileron bellcrank with an improved part and the replacement of any bent rod endsP/N DAI-9027-00-01. In addition, this AD prohibits the reinstallation of P/NDA4-2717-50-00 aileron bellcranks and bent rod ends P/N DAI-9027-00-01 as replacement in the future. |
|---|