Commonwealth legislation

AD/CESSNA 310/53 - Wing Front Spar Lower Attachment Fittings

In ForceCTH

Jurisdiction

Commonwealth

Collection

legislative instrument

Plain English Summary

3/10 complexity

This Airworthiness Directive requires owners/operators of Cessna 310-series aeroplanes to remove the fairing, visually inspect the wing front spar lower attachment fittings (P/N 0822550) for cracks and surface pitting, and repeat inspections at each scheduled Maintenance Release. Compliance is due before a fitting reaches 5,000 hours component time or before the next Maintenance Release after 15 June 1989, whichever is later. Aircraft owners/operators pay for the inspections and any repairs; the Civil Aviation Safety Authority sets the compliance timing and reinspection schedule.

JSON API

Deep dive

Want the full deep dive?

Zoe can write the in-depth analysis on top of the summary above: how it works, who it affects and what each part actually does.

Current sections

Direct links to the current provisions in AD/CESSNA 310/53 - Wing Front Spar Lower Attachment Fittings.

AD/CESSNA 310/53 - Wing Front Spar Lower Attachment Fittings

COMMONWEALTH OF AUSTRALIA (Civil Aviation Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY

SCHEDULE OF AIRWORTHINESS DIRECTIVES

View image in the official source
Cessna 310 Series Aeroplanes

AD/CESSNA 310/53 Wing Front Spar Lower Attachment Fittings 6/89

Applicability: All models.

Requirement: 1. Remove the fairing between the wing and carry-thru and gain access to the wing front spar lower attachment fittings P/N 0822550.

2. Visually inspect the upper and lower edges of the lug of each wing fitting, looking for cracks as shown in the figure below.

3. From inside the wheel well, visually inspect each visible wing fitting for cracks and surface pitting in the area shown in the figure.

Note: It is not necessary to remove the primer for any of the above inspections.

View image in the official source

Wing Fitting Showing Typical Cracking

Note: Fitting Shown removed from aircraft for clarity

Compliance: Before exceeding 5000 hours component time in service or before the issue of the next Maintenance Release after 15 June 1989, whichever is the later. Thereafter, reinspect at each scheduled inspection for issue of a new Maintenance Release.

Background: Fatigue cracking has been discovered in the wing fitting from an Australian-registered Cessna 310R with 6500 hours time in service. No abnormality could be found in the fitting or the aircraft’s history. Since then stress corrosion cracking has been found in a similar wing fitting in a Cessna 402C with 6400 hours time in service.

There is insufficient evidence to regard either of these as isolated occurrences: either or both may be expected to occur at a later time elsewhere in the fleet of Cessna twins which use the same generic wing fitting. A simple repetitive visual inspection has therefore been introduced.

Source text

Sourced from the Federal Register of Legislation (legislation.gov.au), CC BY 4.0.

1 AD/CESSNA 310/53 - Wing Front Spar Lower Attachment Fittings