AIRWORTHINESS DIRECTIVE AIRWORTHINESS DIRECTIVE

AIRWORTHINESS DIRECTIVE

For the reasons set out in the background section, the CASA delegate whose signature appears below issues the following Airworthiness Directive (AD) under subregulation 39.1 (1) of CAR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.

AD/BELL 204/39 Pillow Block Bolts and Ha AD/BELL 204/39 Pillow Block Bolts and Hardware 8/2000

AD/BELL 204/39 Pillow Block Bolts and Hardware 8/2000

Applicability: Model 204B.

Requirement: Action in accordance with the technical requirements of FAA AD 92-23-01.

Compliance: Before further flight after the effective date of this directive, thereafter at each:

each hub assembly,
overhaul,
change of a MR hub retention strap, or
whenever the bolts are removed for any reason.

This Airworthiness Directive becomes effective on 10 August 2000.

Background: This directive follows the detection of cracks in the pillow block bolts on Model 205 and 212 helicopters. Failure of all four bolts will permit main rotor separation. This directive also follows the re-introduction of the AD Series after sixteen years.

David Alan Villiers

Delegate of the Civil Aviation Safety Authority 6 July 2000

The above AD is notified in the Commonwealth of Australia Gazette on 12 July 2000.