Commonwealth legislation

AD/BAL/1 - Brass Nipple Failure

In ForceCTH

Jurisdiction

Commonwealth

Collection

legislative instrument

Plain English Summary

2/10 complexity

This airworthiness directive requires owners/operators of Balloon Works hot-air balloons Firefly 6, 6B and 7 (burners S/No 510–562) to fix a possible brass nipple failure on the burner by installing safety wire or replacing the brass nipple with a steel part. Operators must pay for inspection, parts (Balloon Works P/No A4032B) and labour; the work is required before further flight (or within 5 hours time-in-service) after 30 April 1986 and follows FAA AD 75-17-36.

JSON API

Deep dive

Want the full deep dive?

Zoe can write the in-depth analysis on top of the summary above: how it works, who it affects and what each part actually does.

Current sections

Direct links to the current provisions in AD/BAL/1 - Brass Nipple Failure.

AD/BAL/1 - Brass Nipple Failure

COMMONWEALTH OF AUSTRALIA (Civil Aviation Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY

SCHEDULE OF AIRWORTHINESS DIRECTIVES

View image in the official source
Hot Air Balloons

AD/BAL/1 Brass Nipple Failure 5/86 DM

Applicability: The Balloon Works hot air balloons models, Firefly 6, 6B and 7 fitted with burner S/No 510 to 562.

Requirement: FAA AD 75-17-36.

Install safety wire extending from each of the three corners of the bottom plate to the lower portion of the upper Rego valve body. Assure wires are uniformly tightened.

2. (a) Disconnect main burner tubes from manifold.

(b) Drill out nine rivets holding pan to the bottom plate.

(c) Unhook three burner support springs.

(d) Remove upper burner assembly from lower burner assembly.

(e) Unscrew nuts to remove pilot light tubes.

(f) Clamp square section of Rego valve in vice.

(g) Unscrew and remove burner manifold.

(h) Inspect nipple. If nipple is steel, reassemble burner, if nipple is brass replace nipple with steel nipple, Balloon Works P/No A4032B.

(i) Reassemble burner.

Note: Use teflon tape or pipe dope type sealant on nipple threads. Safety wire (Para 1) is not required after steel nipple is installed.

Compliance: 1 Unless Para 2 already accomplished, before further flight after 30 April 1986.

Within 5 hrs time in service after 30 April 1986.

Background: To avoid separation of burner due to a possible brass nipple failure.

Source text

Sourced from the Federal Register of Legislation (legislation.gov.au), CC BY 4.0.

1 AD/BAL/1 - Brass Nipple Failure