AD/B737/173 Power Distribution Panels 2/2002
Applicability: Model 737-600, -700, and -800 series aeroplanes, equipped with power distribution panels (PDP) bearing any of the following Boeing part numbers, as listed in the "Existing Part Number'' column of the table under paragraph 2.E., "Existing Parts Accountability,'' of Boeing Service Bulletin (SB) 737-24-1128, dated 29 April 1999.
| S281A601-1000 | S281A601-1074 | S281A601-2003 | S281A601-2199 |
|---|
| S281A601-1001 | S281A601-1108 | S281A601-2007 | S281A601-2216 |
| S281A601-1002 | S281A601-1110 | S281A601-2032 | S281A601-2217 |
| S281A601-1003 | S281A601-1111 | S281A601-2038 | S281A601-2220 |
| S281A601-1018 | S281A601-1120 | S281A601-2039 | S281A601-2222 |
| S281A601-1020 | S281A601-1122 | S281A601-2055 | S281A601-2226 |
| S281A601-1045 | S281A601-1128 | S281A601-2057 | S281A601-2228 |
| S281A601-1054 | S281A601-1162 | S281A601-2109 | S281A601-2234 |
| S281A601-1055 | S281A601-1216 | S281A601-2110 | S281A601-2275 |
| S281A601-1056 | S281A601-2001 | S281A601-2111 | S281A601-2434 |
| S281A601-1057 | | | |
Requirement: 1. Unless previously accomplished, perform a one-time general visual inspection to verify proper installation of the power feeder terminals and associated hardware located in power distribution panels (PDP) P91 and P92, in accordance with the following procedures:
Using a flashlight, inspect each of the six power feeder terminals by looking into the access holes located in the plastic cover of the rigid bus assembly. The holes are located on the aft face of PDPs P91 and P92. (Refer to the Boeing 737-600, -700, -800, -900 Aeroplane Maintenance Manual (AMM), Section 24-21-71, Page 402, Figure 401 (Sheet 1), for the location of PDP P91 and P92.) On PDP P91, the holes are adjacent to terminal blocks TB5001 and TB5002. On PDP P92, the holes are adjacent to terminal blocks TB5005 and TB5006. There are a total of six holes per PDP. (Refer to the Boeing 737- 600, -700, -800, -900 AMM, Section 24-21-71, Page 403, Figure 401 (Sheet
2), for the location of the access holes on the PDPs.) Note that although each PDP has nine power feeder terminals, only the six terminals adjacent to the access holes require inspection.