CTHIn ForceLegislation
AD/B717/14 - Horizontal Stabiliser Hinge Fittings and Structure and Elevator Sectors
//
© 2026 Zoe. All rights reserved.
Zoe is a legal information platform. Always consult the Federal Register of Legislation for authoritative text.
AD/B717/14 - Horizontal Stabiliser Hinge Fittings and Structure and Elevator Sectors
Start here
Turn the raw legal text into a practical explanation grounded in AD/B717/14 - Horizontal Stabiliser Hinge Fittings and Structure and Elevator Sectors.
COMMONWEALTH OF AUSTRALIA (Civil Aviation Safety Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY
SCHEDULE OF AIRWORTHINESS DIRECTIVES
Image unavailable in extracted text
AIRWORTHINESS DIRECTIVE
Image unavailable in extracted text
For the reasons set out in the background section, the CASA delegate whose signature appears below issues the following Airworthiness Directive (AD) under subregulation 39.1 (1) of CASR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.
Image unavailable in extracted text
Boeing 717 Series Aeroplanes
AD/B717/14 Horizontal Stabiliser Hinge Fittings and
Structure and Elevator Sectors
7/2004
Applicability: Model 717-200 series aircraft, as listed in Boeing Service Bulletin 717-55-0003, dated 18 June 2002.
Requirement: Inspect in accordance with the technical requirements of FAA AD 2004-08-02 Amdt 39-13571.
Compliance: As specified in the Requirement document, with a revised effective date of 8 July 2004.
This Airworthiness Directive becomes effective on 8 July 2004.
Background: The FAA requires inspections to detect corrosion of the left and right hand horizontal stabiliser hinge fitting bolts, barrel nuts, and associated holes in the horizontal stabiliser structure, and the left and right hand elevator sector pinch bolts and associated holes; which undetected, could lead to loss of a hinge fitting and reduced structural integrity of the horizontal stabiliser.
Image unavailable in extracted text
David Villiers
Delegate of the Civil Aviation Safety Authority 26 May 2004
Image unavailable in extracted text
The above AD is notified in the Commonwealth of Australia Gazette on 16 June 2004.
Page 1 of 1