CTHIn ForceLegislation
AD/A320/179 Amdt 1 - Main Landing Gear - Axle Nut
Airbus Industrie A319, A320 and A321 SerAirbus Industrie A319, A320 and A321 Series Aeroplanes
Start here
Get a plain-English read of Airbus Industrie A319, A320 and A321 Ser
Turn the raw legal text into a practical explanation grounded in AD/A320/179 Amdt 1 - Main Landing Gear - Axle Nut.
Airbus Industrie A319, A320 and A321 Series Aeroplanes
| AD/A320/179 Amdt 1 | Main Landing Gear - Axle Nut | 9/2005 TX |
|---|
| Applicability: | Airbus A320 aircraft, Manufacturers Serial Numbers (MSN) 2275 to 2486 inclusive except MSN 2441, 2447, 2449, 2451, 2453, 2455, 2459, 2475, 2479 and 2484. |
|---|---|
| Requirement: | 1. Inspect the locking bolts, nuts, washers and pins of each Main Landing Gear (MLG) wheel and apply corrective actions, if necessary, in accordance with Airbus All Operators Telex (AOT) A320-32A1303 dated 4 July 2005 or later approved revisions.2. Report the results of this inspection to the aircraft manufacturer.Note: DGAC Emergency Airworthiness Directive (AD) No. UF-2005-128 as approved under EASA reference no. 2005-6092 dated 13 July 2005 refers. AD UF-2005-128 replaces AD F-2005-120 which is cancelled. |
| Compliance: | 1. Unless already accomplished, within 500 flight hours from the effective date of this Directive.2. With in 7 days of inspection per Requirement 1 of this Airworthiness Directive. |
| This Amendment becomes effective on 15 July 2005. | |
| Background: | An A320 operator has reported a brake, wheel position 3, dragging and the relevant brake temperature rising during taxi out. The inspection of the wheel position 3 showed that the axle nut had separated from the axle.The investigation showed that the most probable cause is that locking bolts securing the axle nut were not installed on aircraft whilst on the final production assembly line. The absence of locking bolts, associated nuts, washers and cotter pins can allow the loosening of axle nut and subsequently separation of the wheel from the axle with consequential damage to the gear.The actions specified by this AD address the unsafe condition identified above through inspection for locking bolts, associated nuts, washers and cotter pins installation. |
| The current amendment of this Directives changes compliance time from flight cycles to flight hours but retains rest of the technical content of the original issue.The original issue of this Airworthiness Directive became effective on 12 July 2005. |
|---|
Image unavailable in extracted text
James Coyne
Delegate of the Civil Aviation Safety Authority