sec.60Deciding development applications

### sec.60 Deciding development applications This section applies to a properly made application, other than a part of a development application that is a variation request. To the extent the application involves development that requires code assessment, and subject to section 62 , the assessment manager, after carrying out the assessment— must decide to approve the application to the extent the development complies with all of the assessment benchmarks for the development; and may decide to approve the application even if the development does not comply with some of the assessment benchmarks; and An assessment manager may approve an application for development that does not comply with some of the benchmarks if the decision resolves a conflict between the benchmarks. An assessment manager may approve an application for development that does not comply with some of the benchmarks if the decision resolves a conflict between the benchmarks and a referral agency’s response. may impose development conditions on an approval; and may, to the extent the development does not comply with some or all the assessment benchmarks, decide to refuse the application only if compliance can not be achieved by imposing development conditions. a development condition that affects the way the development is carried out, or the management of uses or works that are the natural and ordinary consequence of the development, but does not have the effect of changing the type of development applied for To the extent the application involves development that requires impact assessment, and subject to section 62 , the assessment manager, after carrying out the assessment, must decide— to approve all or part of the application; or to approve all or part of the application, but impose development conditions on the approval; or to refuse the application. The assessment manager must approve any part of the application for which, were that part of the application the subject of a separate development application, there would be a different assessment manager— other than to the extent a referral agency for the development application directs the refusal of the part under section 56 (1) (c) ; and subject to any requirements of the referral agency under 56(1)(b). The assessment manager may give a preliminary approval for all or part of the development application, even though the development application sought a development permit. If an assessment manager approves only part of a development application, the rest is taken to be refused. For a development application for development requiring social impact assessment, see also section 106ZI . s 60 amd 2019 No. 11 s 148 ; 2025 No. 14 s 86 sch 1 (sec.60-ssec.1) This section applies to a properly made application, other than a part of a development application that is a variation request. (sec.60-ssec.2) To the extent the application involves development that requires code assessment, and subject to section 62 , the assessment manager, after carrying out the assessment— must decide to approve the application to the extent the development complies with all of the assessment benchmarks for the development; and may decide to approve the application even if the development does not comply with some of the assessment benchmarks; and An assessment manager may approve an application for development that does not comply with some of the benchmarks if the decision resolves a conflict between the benchmarks. An assessment manager may approve an application for development that does not comply with some of the benchmarks if the decision resolves a conflict between the benchmarks and a referral agency’s response. may impose development conditions on an approval; and may, to the extent the development does not comply with some or all the assessment benchmarks, decide to refuse the application only if compliance can not be achieved by imposing development conditions. a development condition that affects the way the development is carried out, or the management of uses or works that are the natural and ordinary consequence of the development, but does not have the effect of changing the type of development applied for (sec.60-ssec.3) To the extent the application involves development that requires impact assessment, and subject to section 62 , the assessment manager, after carrying out the assessment, must decide— to approve all or part of the application; or to approve all or part of the application, but impose development conditions on the approval; or to refuse the application. (sec.60-ssec.4) The assessment manager must approve any part of the application for which, were that part of the application the subject of a separate development application, there would be a different assessment manager— other than to the extent a referral agency for the development application directs the refusal of the part under section 56 (1) (c) ; and subject to any requirements of the referral agency under 56(1)(b). (sec.60-ssec.5) The assessment manager may give a preliminary approval for all or part of the development application, even though the development application sought a development permit. (sec.60-ssec.6) If an assessment manager approves only part of a development application, the rest is taken to be refused. - (a) must decide to approve the application to the extent the development complies with all of the assessment benchmarks for the development; and - (b) may decide to approve the application even if the development does not comply with some of the assessment benchmarks; and Examples— 1 An assessment manager may approve an application for development that does not comply with some of the benchmarks if the decision resolves a conflict between the benchmarks. 2 An assessment manager may approve an application for development that does not comply with some of the benchmarks if the decision resolves a conflict between the benchmarks and a referral agency’s response. - 1 An assessment manager may approve an application for development that does not comply with some of the benchmarks if the decision resolves a conflict between the benchmarks. - 2 An assessment manager may approve an application for development that does not comply with some of the benchmarks if the decision resolves a conflict between the benchmarks and a referral agency’s response. - (c) may impose development conditions on an approval; and - (d) may, to the extent the development does not comply with some or all the assessment benchmarks, decide to refuse the application only if compliance can not be achieved by imposing development conditions. Example of a development condition— a development condition that affects the way the development is carried out, or the management of uses or works that are the natural and ordinary consequence of the development, but does not have the effect of changing the type of development applied for - 1 An assessment manager may approve an application for development that does not comply with some of the benchmarks if the decision resolves a conflict between the benchmarks. - 2 An assessment manager may approve an application for development that does not comply with some of the benchmarks if the decision resolves a conflict between the benchmarks and a referral agency’s response. - (a) to approve all or part of the application; or - (b) to approve all or part of the application, but impose development conditions on the approval; or - (c) to refuse the application. - (a) other than to the extent a referral agency for the development application directs the refusal of the part under section 56 (1) (c) ; and - (b) subject to any requirements of the referral agency under 56(1)(b).